Comparison between static and dynamic behavior measured in triaxial and oedometric test systems
- Forfattere
- Mohammad Hossain Bhuiyan
- Rune Martin Holt
- Jørn F Stenebråten
- År
- 2011
- Type
- Konferanseforedrag
Marching Cubes (MC) is an algorithm that extracts surfaces from volumetric scalar data. It is used extensively in visualization and analysis of medical data from modalities like CT and MR, usually after a 3D segmentation of the structures of interest have been performed. Implementations of MC on CPUs are slow...
Uklart mht ISSN-nr. ISSN 1455-4186 er samme tidsskrift men som er poenggivende....
...gives a status report on the flight experiment ANITA (Analysing Interferometer for Ambient Air), the development status of the successor unit ANITA II and spin-off activity such as the use of an ANITA-type instrument on a submarine. The ANITA system represents a precursor for ANITA II, a permanent continuous...
...positive association between safety climate and the safety behavior of sharp-end workers in high-risk organizations is supported by a considerable body of research. Previous research has primarily analyzed two components of safety behavior, namely safety compliance and safety participation. The present study...
...how replacing a fraction of Mg with Li in a lean Al-Mg-Si alloy gives comparable strength and enhanced temperature stability. Replacing solute with smaller amounts of Cu and Li also improves thermal stability and nearly compensates the strength loss for longer ageing times. The Cu addition was kept at...
Equilibrium distribution and transport kinetics of boron between ferrosilicon and calcium silicate slag were investigated through experimental study. A 50 pct CaO-50 pct SiO2 slag (by weight) was held for different durations at 1873 K (1600 °C) in a graphite tube furnace together with boron-doped ferrosilicon...
...strength (UCS) and filtration stability of grouts made up of three types of cement commonly used for tunnel grouting in the Nordic countries. Since in-situ tunnel conditions are different from those of the laboratory in terms of temperature, we made various cement grouts at different temperatures and tested...
...(Ti) and silver (Ag) nanomaterials are increasingly released to urban wastewater treatment plants (WWTPs) from households and industrial facilities. In the current study, we assessed the occurrence of Ti and Ag in WWTP influents and their elimination in full-scale WWTPs employing preliminary and primary...
...macroalgae at the lowest trophic level, using only sunlight and nutrients from the sea while taking up CO:z, will have a neutral carbon footprint and the biomass will contribute significantly to meet the demand for food, feed, materials, chemicals, fuels and pharmaceuticals in near future. Through a new bioeconomy...
Expectations on how social intranets will improve knowledge sharing and collaboration in enterprises are high. Yet research into user patterns of traditional SNSs demonstrates participatory divides, and differences in use can be expected with social intranets. In this paper we report on the findings...
The precipitate microstructure and vacancy distribution in Al-Mg-Si alloys with different amounts of solute and different heat treatments were investigated by transmission electron microscopy and muon spin relaxation measurements. A high amount of vacancies is normally present in Al-Mg-Si alloys as these...
...temperature swing adsorption (TSA) process. Adsorption equilibrium of CH4 and CO2 on commercial zeolite 4A and zeolite 13X is reported at cryogenic temperatures: 198, 208, 223, 248, and 279 K. Carbon dioxide is much more adsorbed than methane, and CO2 isotherms are extremely steep at low temperatures. In the studied...