Søk i SINTEF

In: Sipinen, S.A.; Leiniö, M. (eds) Proceedings from the XXIth Annual meeting of EUBS 95, on Diving and Hyperbaric Medicine, Helsinki, Finland, June 28th-July 1st, 1995, pp 61-66....

In: Brakstad A, Lindrup AG (eds): Nutec-Fudt seminar innen Dykketeknologi og dykkemedisin/fysiologi, Bergen, 21. og 22. november 1995, p 37....

Kuklane K, Holmèr I and Ekeberg C. (Eds.). Proc. International Symposium on Problems with Cold Work. National Institute for Working Life, Stockholm, 1997. Arbete och Helsa 1998:1, 137-140...

Kuklane K, Holmér I and Ekeberg C (Eds.). Proc. International Symposium on Problems with Cold Work. National Institute for Working Life, Stockholm, 1997. Arbete och Helsa 1998:1, 11-16...

In: Environmental Ergonomics VIII, JA Hodgdon et al. (Eds.) Environmental Ergonomics, Proceedings from the 8th International Conference on Environmental Ergonomics, San Diego, California, 19th – 23rd October, 1998. pp 19-23...

In this paper, we described the design and construction of a new two-capillary viscometer with several novel technical solutions for viscosity and density measurements. Our design, which is based on the low-pressure principle, featured numerous improvements in hardware and procedure that allowed the...

Ammonia is a promising energy carrier for the green transition, but its hygroscopicity and toxicity necessitate in-depth understanding of its interaction with water. This work examines the bulk and interfacial thermodynamics of the ammonia–water system. Parameters for three equations of state are...

The paper presents a commercial refrigeration system using CO₂ as refrigerant. The seasonal COPs are calculated, and a comparison is done with a conventional system using R404A. It appears that the annual energy consumption is 8% higher than the equivalent R404A solution. The cost of the CO...

Controlled pyrolysis experiments have been performed on five different biomass types that include birch and spruce woodchips, wood pellets, steam exploded pellets and birch bark. Biocarbons have been produced at a temperature of 1000 °C at a slow heating rate of 10 °C/min. The focus of this work was...

In: Environmental Ergonomics VIII, JA Hodgdon et al. (Eds.) Environmental Ergonomics, Proceedings from the 8th International Conference on Environmental Ergonomics, San Diego, California, 19th-23rd October, 1998. pp 174-177...

Proceedings NOKOBETEF 6th and European Conference on Protective Clothing 1st, Stockholm Sweden, May 7-10, 2000...