PlastiCircle aims to develop and implement a holistic process to increase recycling rates of packaging waste in Europe. This will allow to reprocess plastic waste in the same value chain. This...
This is a large industrial project between Nobina AB in Sweden and SINTEF Optimisation. The project focuses on building a personnel scheduling engine - SkiftOpt - that matches bus drivers to...
EU 4REFINERY will develop and demonstrate the production of next generation biofuels from more efficient primary liquefaction routes integrated with upgraded downstream (hydro)refining processes...
Understanding the cost of retrofitting CO2 capture to an integrated oil refinery In this project a study was made of the performance and cost of CO2 capture integrated into four...
The objective of this project is to develop the future protective clothing for workers handling molten metal with improved overall protection for increased safety, performance and comfort during...
Giantleap aims to increase lifetime and reliability of fuel cells in buses After the encouraging results of the Sapphire project, SINTEF leads the Giantleap project, which through similar...
Learning Flexibility: Complexity, Innovation & Inter-Urban Knowledge Transfer focusses on flexible and sustainable cities by identifying novel lessons and knowledge from cities facing...
The main objective for the MonitorX project is to develop a model, and an additional software prototype, for optimal utilization of the lifetime of a component in a hydropower plant. The MonitorX...
The PLATIRUS project aims at reducing the European deficit of Platinum Group Metals (PGMs), by upscaling to industrial relevant levels a novel cost-efficient and miniaturised PGMs recovery and...
The performance of elastomeric polymers depends on their environment, especially the local temperature. In order to develop successful seals for use in arctic oil production, new elastomer...
Expertise FerroCool is an experimental project that will investigate ferrofluid heat transfer. It is an early step towards realizing a novel, efficient and reliable cooling concept that uses...
Additive manufacturing (AM), often referred to as 3D printing, has received a lot of attention recently. The overall idea of the AddForm project is to use rather inexpensive mould inserts, made by...
This project is helping the municipality of Stjørdal with deciding how many new flats for assistant living they shall build in the near future and how they shall be designed. How they shall...
Snow conditions have an important impact on nature and human society. In Norway, one third of the annual precipitation falls as snow and snow information is important economically (hydropower),...
NEXUS is a research project that has received support from SAMRISK II program of the Research Council of Norway for the period 2014 to 1st of July 2017. SAMRISK II program aims to "increase...
The project Predict-RPT has sought to improve our understanding of the phenomenon of rapid phase transition (RPT). This is becoming an important safety issue as the transport and utilization of...
...universAAL was a European FP7 funded project led by SINTEF. In this page you will find some information about the project, and links to follow-up activities by universAAL partners. universAAL's...
The main objective of EcoManage is to test, evaluate and adapt new concepts and indicators for the improved development and management of energy and water resources. The selected set of concepts...
EU Transmission for sustainability The Best Paths project will help to overcome the challenges of integrating renewable energies into Europe's energy mix. With nearly 40 leading organisations...
The main objective is to optimize the chemical quality of silicon for siloxane and silicones production in order to boost the process efficiency and productivity. CorSiCa project will develop a...