Dry peel plies are generally used in composite manufacturing by liquid moulding techniques in the maritime sector. They allow excess resin to bleed through its weaved structure, keeping the surfaces clean, and in certain cases with the required roughness until ready for bonding. However, these plies...

This article presents a feasibility study where fibre-reinforced structural elements are assembled into long slender columns using adhesive bonding. The columns are intended to be part of an externally guyed high-voltage transmission tower where they are subjected to a combination of compressive and...

This paper presents a study of traditional netting materials subjected to disinfecting chemicals during fish farming and treatment of net cages. A series of tests were performed in order to study the effect of various concentrations of disinfecting chemicals on the tensile strength of Raschel knitte...

This paper presents a study of traditional netting materials subjected to disinfecting chemicals during fish farming and treatment of net cages. A series of tests were performed in order to study the effect of various concentrations of disinfecting chemicals on the tensile strength of Raschel knitte...

A new rapid prototyping method is reported. It is based on injection molding with inexpensive mold inserts, 3D-printed in durable polymer-based materials. The method allows for manufacturing of microfluidics in common thermoplastics materials at a lower cost and with shorter lead-times compared to i...

An experimental study of the role of sub-zero temperature impact damage and subsequent freeze-thaw exposure on post impact compression strength of quasi-isotropic glass fibre reinforced vinyl ester resin composite materials using non-crimp reinforcements typically applied in the marine industry is p...

The effect of ageing in a sweet oil environment on the tensile properties, apparent crosslink density, CO₂ diffusion and Shore hardness of a typical carbon black reinforced hydrogenated nitrile butadiene rubber (HNBR) is presented. Different ageing conditions yielded materials with different propert...

Distributions of shear strains and strain states (triaxiality) were analysed for two in-plane shear test fixtures (Iosipescu and V-notched rail), using digital image correlation and numerical simulations. Three different polypropylene-based materials (two talc-filled compounds and one unfilled homop...