SINTEF projects

SICALC is a new service model for calculation of air traffic noise.

Digital twins for Operational Management Systems (OMS) and production analytics

In this study SINTEF has focuses on circular economic opportunities that are expected to have a large potential for reducing the climate gas emissions associated with Norwegian consumption and production. Over a dozen circular strategies were...

The long-term objective for Technology and global health is to position SINTEF as an important resource of existing and new technologies that contribute to preventing and reducing health problems and to improve health services in low-income countries...

The main aim of the VIRTUAL-FCS project is to make the design process of hybrid fuel cell and battery systems easier, cheaper and quicker.

The main goals of the μBIOSEP project are the introduction of micromachined ESI interfaces and miniaturized devices enabling automated analyses of samples on the same, on-chip integrated LC separation column.

Better storage of industrially produced potatoes for less wastage, higher quality and reduced content of acrylamide.

The goal of the project is to enhance meteorological information, both measured and forecast, for use in novel air traffic management tools supporting enhanced time based and weather dependent separation modes for airport arrival and departure runway...

The project PJ.09, Digital Network Management Services, aims to improve network traffic predictability and shared complexity representation for all demand capacity balancing (DCB), dynamic airspace configuration (DAC), integrated network management...

SINTEF has developed software to enhance the situational awareness of air traffic controllers (ATCOs) in remote towers. Various automation features and techniques support them by improving their spatial and temporal perception.

Cyber security is a key enable for safe Air Traffic Management. SINTEF is part of a team of experts, dedicated to helping European ATM projects to integrate security in their research and development activities.

In many places, the low-voltage grid in Norway is so weak that secure disconnection in the case of short circuits in the network or in the customer's installations cannot be guaranteed.

The primary objective of SAM is to optimize demanding industrial processes by developing advanced physical models and machine learning algorithms, and integrating new online sensors where real time data is currently limited or lacking.

Madshus is the oldest, still operating, producer of cross-country skis. The factory delivers advanced racing and entry level skis with regards to material quality, design, weight and defined ski properties.

A new software developed by SINTEF makes it more efficient to plan daily airport operations, reducing delays, aircraft idling and recovery time.

The Indian government has strongly promoted the development of solar energy in recent years. By 2022, a dramatic increase in solar energy production is expected with an ambitious target of 100 GW installed power.

Gentle Robotic Manipulation of 3D Compliant Objects.

Gear systems are critical in maritime vessels and wind turbines, and damage of components in these systems may lead to catastrophic and costly failure. Today, gears and bearings are often monitored by frequent inspections and manual condition...