To main content

Gas technology

Gas technology

You are here:

SINTEF’s work helps safeguard the value of Norwegian gas in the international market. We have world-leading research expertise in natural gas liquefaction, gas transport in demanding areas over long distances and process and component development.

Contact person

Mona Jacobsen Mølnvik
Research Director
930 08 868

Expertise

CCS Value Chain

CCS chains are case and scenario sensitive, and each case often requires individual design for reaching the optimal solution. The main objective is to develop a consistent and transparent methodology and simulation tool for integrated techno-economic and environmental CCS chain assessment. The ambition is to enable selection of the most promising alternatives for CO2 chains and reduce uncertainty by improving knowledge and by developing adequate solutions for managing risk in CCS
Amy Brunsvold
Senior Research Scientist
930 02 419

CFD - Computational Fluid Dynamics

The CFD group at SINTEF Energy Research has more than 30 years of experience in performing numerical modelling of chemically reactive processes in laminar and turbulent flows consisting of single-phase (gaseous fuels combustion) or multi-phase (solid fuels combustion) configurations. Depending on the specific needs and time constraints of our customers, we are able to perform numerical simulations that boast a wide range of accuracies, geometric complexity and computational cost.
Andrea Gruber
Senior Research Scientist
905 52 134

CO2 as working fluid for refrigeration, air conditioning, heat pump systems and power cycles

CO2 has gone through a renaissance as refrigerant due to the need to replace the chemical refrigerants with highly negative environmental impact. The main applications where CO2 systems has been commercialized so far are heat pump water heaters (heat pumps for heating of sanitary water), refrigeration systems for supermarkets and within small size commercial refrigeration. SINTEF-NTNU initiated this development in the end of the 1980s. More than 4 million systems are installed to date, corresponding to a turnover of more than 200 billion NOK.
Petter Nekså
Chief Scientist
926 06 519

CO2-capture: Process modelling and simulation

Modelling is important for understand the mechanisms associated with the separation of CO2 from large point sources such as fossil fuel power plants, steel works and similar. Modelling tools can be used for plant design process optimization and system improvement. SINTEF has developed a simulation software package, CO2SIM, for simulation of absorption based CO2 capture, tailored for this purpose.
Finn Andrew Tobiesen
Senior Research Scientist
982 83 947

Combustion processes for CO2 capture technolgy

We have accumulated more than 15 years experience in new combustion processes based on the use of unconventional fuels (rich in hydrogen) and new oxidizers like oxyfuel mixtures which are common in power and industrial technologies with CO2 Capture and Sequestration (CCS). We also support the development of new CCS concepts and bring them to pilot testing as we do for the promising Chemical Looping Combustion (CLC) technology.
Mario Ditaranto
Senior Research Scientist
476 70 869

Hydrogen technology and energy storage

Hydrogen will be an important supplement to electricity as an energy carrier in future sustainable energy systems. In addition to being fuel for the transport sector, hydrogen will contribute to increased utilization of renewable energy sources. The need for energy storage will increase dramatically, and hydrogen will be the preferred option for large amounts of energy, and storage over longer periods.
Steffen Møller-Holst
Vice President - Marketing
926 04 534

Laboratories

CO2 laboratory, Tiller

The CO2 laboratory at Tiller is a highly equipped test facility for development of post-combustion CO2 capture technologies, as well as a research lab for flue gas pre-treatment analysis and emission research.

ECCSEL Norway CCS RI

– the Norwegian node of ECCSEL RI

Gas conversion laboratories

The gas conversion laboratories at SINTEF consists several customizable units for investigating catalytic reactions at industrially relevant conditions. Project activity has been ongoing for more than 30 years in close collaboration with the industry and academia.
See more laboratories on Gas technology

Projects

CARBIOMEMBEX - Novel biocatalytic membrane technology for the efficient removal of CO2 in Recirculating Aquaculture Systems

10 August 2018

CO2 removal from process water is an essential component of land-based aquaculture. CARBIOMEMBEX aims at developing novel technology for CO2 separation in aquaculture by combining state-of-the-art membrane technology and biocatalysis into innovative enzyme-membrane contactor systems for efficient CO2 removal from water.

Current interruption in supercritical fluids

07 May 2018

An increasing number of windfarms located far off the coasts and a growing demand for electric power supply to oil and gas installations on the seabed will lead to a development of an off-shore electric power transmission infrastructure.

COMPACTS2

19 February 2019

COMPACTS2 aims to validate methodology for design of more compact, lightweight and robust steam bottoming cycles that will promote their implementation in offshore oil and gas production.
See more projects on Gas technology

News

Updates from the Mont Terri experiment: Studying Caprock and Fault Sealing Integrity

17 October 2018

The geological storage of CO2 is an essential component for enabling the efficient generation of emission-free hydrogen (H2) as a transport fuel. The large volumes of CO2 produced in the natural gas reforming H2 manufacture require a coupling with direct CO2 separation techniques, and safe geological storage.

The EERA conference – 10 years of lowering Europes CO2

26 June 2018

Nils Røkke is the Chairman of the European Energy Research Alliance (EERA). This is his opening speech for the EERA 10-year anniversary. Last year, when we started to think about the EERA 10-year anniversary, the first question was whether to have an internal gathering of the EERA research community, or to celebrate it with partners and friends who have shared – and will share – this journey with us. The answer was quite immediate, and I am very pleased that today I can welcome representatives of both EERA and of the European energy research and innovation community at large.

SINTEF Energy/NTNU article included in prestigious collection

04 June 2018

Ph.D candidate Ailo Aasen has together with myself (his supervisor) and Edgar M. Blokhuis, a research partner at the University of Leiden in the Netherlands, published a new article in the well reputed Journal of Chemical Physics.
See more news on Gas technology